Seal-All How To 050307

Questions About Seal-All^®
	What are the directions for using Seal-All^®?
	What is the most unique feature of Seal-All^®?
	What substrates will Seal-All^® bond to?
	How long does it take for Seal-All^® to dry?
	Is Seal-All^® a thick or thin consistency adhesive?
	Is Seal-All^® UV resistant?
	What are some suggested uses for Seal-All^®?

Directions:

Read complete directions before use.

To open, break seal with pointer cap. Hold tube upright until ready to use. Do not squeeze tube to force
opening. Replace cap after each use.
Always test a small area before full use.
USE AS A SEALANT: Apply directly to clean, dry surface. Hold firmly until product sets. Additional coats may be
applied. Allow each layer to dry thoroughly. On leaking objects under pressure, tape over Seal-All^® with duct® or masking tape. Additional coats may be applied over tape.
USE AS A CONTACT ADHESIVE: Spread coating on each surface to be joined together. Allow to harden for
5-10 minutes, then press both surfaces together. Seal-All^® hardens by solvent evaporation and forms an
immediate bond that is difficult to reposition after both adhesive coated surfaces are placed in contact and
sufficient pressure is exerted to create full contact between both surfaces.
DRY TIME: Seal-All^® will hold in about 2-3 minutes and reaches full cure in 2-6 hours. Cure time increases with
lower temperatures and decreases with higher temperatures.
TEMPERATURE RANGE: -40° F (-40° C) to 150 F (66° C)
UV RESISTANCE: For maximum UV resistance, paint over Seal-All.
CHEMICAL RESISTANCE: Resistant to gasoline, alcohol, paint thinner and most solvents.
WATER RESISTANCE: Water resistant immediately upon application.

For technical support contact our Technical Service department by mail, email, or phone. Our office hours are 7:30 a.m. - 4:00 p.m. (CST) Monday through Friday. Please contact us for more information.

To request a Material Safety Data Sheet (MSDS) please send an email to msds@eclecticproducts.com

Answers to Seal-All Questions

What is the most unique feature of Seal-All^®?

Seal-All^® is resistant to gasoline, oil, paint thinner, and most solvents. Seal-All is also water resistant immediately upon applications.

What substrates will Seal-All^® bond to?

Seal-All^® adheres with superior strenth to all substrates and materials except paper, cardboard and Styrofoam^™. Always test a small area before full use.

How long does it take for Seal-All^® to dry?

Seal-All^® will hold in 2-3 minutes.*
Reaches full-cure in 2-6 hours.*

*Remember temperature and huitiy will affect dry time.

Is Seal-All^® a thick or thin consistency adhesive?

Thin consistency.

Is Seal-All^® UV resistant?

No. Cured Seal-All^® may be painted over for maximum UV resistance.

What are some suggested uses for Seal-All^®?

Here are a few of the ways that you can use Seal-All^®:

AUTO: use for distributor caps, interior panels, radiatos, gaskets, transmission carburetor floats, body and trunk leaks, battery cables and terminals, generators, tools and much more.

GARAGE/SPORTING: use to repair and maintain oil pans, gasoline tanks, oil lines, golf club grips, fletching arrows,s fishing rod tips and guides tents, canoes, boats, outboard motos, fishing lures, woodworking, model kits and more.

HOME/CRAFT: use to repair and maintain glass, china, crockery, leather, metal, porcelain, fiberglass, most plastics, ornaments, figurines, linoleum, oil cloth, furniture, knobs and drawer pulls, screens, tile, plumbing, gutters and much more.