Checkout our 2 part &
Anti-Skid epoxy products:

SuperMEND product image     SuperMEND®

marine fix fast product image     Marine

superweld product image     Automotive®

Anti-Skid product image     All Pupose &
Bath, Tub & Tile

FREQUENTLY ASKED QUESTIONS (FAQs)

What is Coat-It and what is it used for?
Coat-It is a 100% solids waterproof graphite black epoxy sealer and coating. Its original application is an armor plating type high build coating for the bottom of fishing boats, kayaks and canoes. Cured Coat-It creates slip and lubricity when the boat comes into contact with rocks, gravel or shrubs as well as protects boats from damage. Coat-It can also be used to create a non-skid surface on decks, steps or ramps by spreading medium to fine silica sand over the wet Coat-It. Allow to harden completely and remove excess sand.

What surfaces will Coat-it work on?
Coat-it bonds very well to aluminum, steel, fiberglass and wood surfaces.

What makes Coat-It so tough?
Coat-It contains ceramic beads for abrasion resistance, graphite for slip or lubricity and Kevlar® fiber (the same Kevlar® fiber used in bullet proof vests) for extreme toughness.

What is the coverage area?
Coat-It comes in both 2 lb. and 8 lb. kits.
2 lb. kit: 20 square ft.*
8 lb. kit: 80 square ft.*
*depends on porosity of surface and thickness applied.

What is the dry time for Coat-It?
Mixed Coat-It should be applied within 30 minutes. Adequate dry time is approximately 10-12 hours @ 70°F (21°C) (less than half the time of competitive brands). Cure time decreases with higher temperatures and increases with lower temperatures. Thick coats cure faster than thin coats.

Can Coat-It be used in conjunction with fiberglass cloth for additional strength?
Yes. Use fiberglass cloth for added strength at plywood joints, etc. When using fiberglass fabrics, use a squeegee for smoothing and spreading resin. When coating large areas, use a foam roller. Using this type of roller assures a smooth uniform finish when applied according to directions.

Can Coat-It be painted?
Yes. For maximum ultraviolet protection, allow Coat-It to cure thoroughly, sand lightly and apply a good grade of marine paint or Famowood Dura-Tuff (above water surfaces only).

What are Coat-It's warranty specifications?
LIMITED WARRANTY: The product is warranted against any defect in materials or workmanship, providing a claim is made in writing within 180 days after the sale of the product. THE EXCLUSIVE REMEDY FOR ANY DEFECTS IN MATERIALS OR WORKMANSHIP SHALL BE OBLIGATION OF THE SELLER TO REPAIR OR REPLACE ANY PRODUCT WHICH SHALL BE DETERMINED, TO THE SATISFACTION OF SELLER UPON SELLER'S EXAMINATION, TO HAVE BEEN THUS DEFECTIVE.

SELLER MAKES NO EXPRESS OR IMPLIED WARRANTIES OF ANY KIND, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND OF FITNESS FOR ANY PARTICULAR PURPOSE OTHER THAN STATED HEREIN. THE REMEDIES PROVIDED HEREIN ARE THE EXCLUSIVE REMEDIES TO BUYER, AND SELLER SHALL NOT BE LIBEL FOR ANY LOSS, INJURY, OR DAMAGES TO PERSONS OR PROPERTY RESULTING FROM FAILURE OF THE PRODUCT OR ANY DEFECT IN THE PRODUCT SOLD HEREUNDER, OR ANY DELAY IN PERFORMANCE BY SELLER, NOR WILL SELLER BE LIABLE FOR DIRECT, INCIDENTAL, CONSEQUENTIAL, SPECIAL OR ECONOMIC DAMAGES OF ANY KIND, OR FOR CONTRIBUTION OR INDEMNITY CLAIMS, HOWEVER CAUSED, WHETHER FOR BREACH OF WARRANTY, CONTRACT, TORT (INCLUDING NEGLIGENCE), STRICT LIABILITY, OR OTHERWISE.