E6000 logo

E6000 Series product image

E6000® SERIES ADHESIVES

HOW TO USE

Follow these step-by-step directions when using
E6000® Series of Industrial Strength Adhesives:

  1. Use in a well-ventilated area only. Surface should be clean, dry and free from dirt. Roughen surface before use. Best when used between 70 °F (21°C) and 85 °F (29 °C).
  2. Apply E6000 directly to the area to be repaired. For maximum strength, allow bond to dry for 24-72 hours. Cure time increases with lower temperatures and decreases with higher temperatures. Set on low and do not hold directly on E6000.
  3. Clean uncured adhesive with acetone or naphtha. Cured material may be removed by cutting and scraping.
  4. E6000 is not recommended for use on Styrofoam, polystyrene, polyethylene or polypropylene plastics.

For technical support, contact our Technical Service Department by mail, email, or phone. Our office hours are 7:30 A.M. - 4:00 P.M. (Central) Monday through Friday. Please contact us for more information.

To request a Material Safety Data Sheet (MSDS) please send an email to msds@eclecticproducts.com

©2012 Eclectic Products, Inc. - Eugene OR
home | about | msds | tds | literature | craft projects | articles | videos | photo gallery | contact us | site map