Checkout our 2 part &
Anti-Skid epoxy products:

    SuperMEND®

    Marine

    Automotive

    Coat-It®

    All Pupose &
Bath, Tub & Tile

HOW TO USE

Follow these step-by-step directions when using Amazing GOOP® Epoxies:

1. Refer to working/set time and full cure time of each Amazing GOOP Epoxy Paste.
2. Surface should be clean, dry and free from all contaminants such as dirt, grease, oil, rust and paint. for best results, roughen surface with coarse sandpaper or file.
3. Always prime porous surfaces (wood, concrete) with a thin squeegee coat of the same epoxy before the initial thick coat is applied.
4. Mix equal amounts by volume, side A and side B, in clean round mixing container, preferably new paper cups or buckets. DO NOT attempt mixing on a flat surface. DO NOT vary the 1-to-1 ratio for any reason.
   NOTE: Sufficient stirring and mixing is the most important step for satisfactory results with Amazing GOOP Epoxies.
5. Best when used between 70 °F (21 °C) and 85 °F (29 °C).
6. Stir and mix thoroughly or 2 1/2 minutes, scraping sides and bottom often, and use a fold-into-center motion so both sides can be blended.
7. Once the epoxy is thoroughly mixed, you may refer to the individual Amazing GOOP Epoxy Paste working/set time and temperature information noted to complete the project.
8. Full cure time varies depending on which Amazing GOOP Epoxy Paste product is being used. Once cured, the project may be sanded, ground, filled, tapped, sawed, drilled and painted with most paints. Cure time decreases with higher temperatures and increases with lower temperatures. Thick coats cure faster than thin coats.
9. Clean tools with acetone or lacquer thinner. Use plenty of soap and water to remove epoxy from skin.

For technical support, contact our Technical Service Department by mail, email, or phone. Our office hours are 7:30 A.M. - 4:00 P.M. (Central) Monday through Friday. Please contact us for more information.

SuperMend® MSDS (Resin & Hardener) — EN
SuperMend® MSDS (Resin & Hardener) — FR
SuperMend® MSDS (Resin & Hardener) — SP
Marine MSDS (Resin & Hardener) — EN
Marine MSDS (Resin & Hardener) — FR
Automotive MSDS (Resin & Hardener) — EN
Automotive MSDS (Resin & Hardener) — FR
Coat-It® MSDS (Resin & Hardener) — EN

   NOTE:

• To avoid skin contact, disposable gloves are recommended.
• If contents on either side appear crystallized or solid, apply moderate heat (120 °F (49 °C) to 130 °F (54 °C)) until contents return to soft putty state. Allow to cool before mixing side A with side B.