Instant Wood Repair

FAMOWOOD® Instant Wood Repair -
Two-Component Polyurethane Resin System

How To Use

6.1 fl oz / 180 mL Instructions and Notes

Read all instructions, safety precaution, and application notes before using FAMOWOOD Instant Wood Repair.

  1. Wood surface should be clean, dry and free from oil and grease before area is filled. A dry surface will minimize foaming of material. Paint and/or rotten wood must be removed. Any rotten wood remaining will continue to rot once repair has cured. When working on painted wood, make sure paint is well adhered to wood. Loose paint chips will affect overall adhesion to wood.
  2. Hold the cartridge upright to prevent liquid material from escaping during assembly. Unscrew the retaining nut on the top of the cartridge to remove the nose plug. See Illustration#1 & #2 below.
  3. Holding the cartridge upright, place the mix tube onto the top end of cartridge set and replace the retaining nut. To prevent leakage, make sure the mix tube assembly is fully secured with the retaining nut tight. See Illustration #3 below.
  4. Place cartridge into dispensing gun. Make sure the retaining nut is outside the frame assembly of the dispensing gun. Push plunger rod forward to be engaged with cartridge. See Illustration #4 below.
  5. Hold dispensing gun upright and depress the trigger to slowly fill mix tube. See Illustration #5 below.
  6. Fill the entire mixing tube with FAMOWOOD Instant Wood Repair while pointing the mix tube upward.
  7. After filling mix tube, be sure to properly discard the first inch of dispensed material into a waste container to ensure the polyurethane components are mixed in the same ratio. This will result in consistency in the final product properties. The fully mixed color is light brown, and color is reached, immediately dispense into the area to be filled or repaired. DO NOT STOP DISPENSING FOR MORE THAN 1 MINUTE as the material may cure in mix tube. When flow of resin coming out of the mix tube slows down, it is time to replace mix tube.
  8. When a clean finish is desired and sanding is not possible, it is recommended to protect adjacent surfaces with painter's tape. Material can be troweled for approximately 3 minutes at optimal application temperatures between 65 °F to 85 °F (18 °C to 29 °C). Troweling after the 3 minute working time may result in some of the material pulling out of repair. Remove tape as soon as possible after applying FAMOWOOD Instant Wood Repair.

    NOTE: Polyurethanes cure faster at warmer temperatures and slower at cooler temperatures. A large repair will cure faster than a small repair.

  9. To help prevent the material from dispensing during the troweling step, set dispensing gun aside, depress release lever and pull plunger rod back to start position.
  10. Material can be machined, sanded, planed and painted within 1 hour after application at 70 °F (20 °C).
  11. To remove emply cartridge, depress release lever, pull plunger rod back to start position and pull cartridge out. See Illustration #6 below.

NOTE: The caulk gun will only move half-way down the caulk tube, at that point the tube has been completely dispensed.

Safety & Supplies
Product & Application Notes

For PRODUCT SUPPORT contact: Technical Support by phone at 800-767-4667 or email info@eclecticproducts.com.

Find out more:
back to FIWR beginning
Safety Precautions
Sell Sheet
Technical Data Sheet
msds@eclecticproducts.com