Instant Wood Repair
FAMOWOOD® Instant Wood Repair -
Two-Component Polyurethane Resin System
How To Use
6.1 fl oz / 180 mL Instructions and Notes
Read all instructions, safety precautions, and application notes before using FAMOWOOD Instant Wood Repair.
- Use safety eyeglasses, latex/nitrile gloves and a drop cloth when using the FAMOWOOD Instant Wood Repair system.
- CAUTION! Curing process produces heat. Polyurethane reaction is exothermic. Dispensed material can become hot during application and curing, especially when applied in large volumes. Keep away from children.
- When a clean finish is desired and sanding is not possible, it is recommended to protect adjacent surfaces with painter's tape. Material can be troweled for approximately 3 minutes at optimal application temperatures between 65 °F to 85 °F (18 °C to 29 °C). Troweling after the 3 minute working time may result in some of the material pulling out of repair. Remove tape as soon as possible after applying FAMOWOOD Instant Wood Repair.
- Read Material Safety Data Sheets carefully. Use the link at the bottom of this page to request a MSDS or call 800-333-9826 (Willamette Valley Company Safety & Compliance).
- Set time is approximately 5 minutes at optimal temperature range between 65 °F to
85 °F (18 °C to 29 °C). Product may be applied at temperatures outside of this range (35 °F to 100 °F / 2 °C to 38 °C). However, working time and tack free time may be shorter or longer. - After filling mix tube, be sure to properly discard the first inch of dispensed material into a waste container to ensure the polyurethane components are mixed in the same ratio. This will result in consistency in the final product properties. The fully mixed color is light brown, and color is reached, immediately dispense into the area to be filled or repaired. When flow of resin coming out of the mix tube slows down, it is time to replace mix tube.
- Unused material can be saved for later use by removing the mix tube and replacing the nose plug cap and keeper ring or by keeping the used mix tube intact.
- The mixed resin can be applied to flat, sloped and/or vertical surfaces without running, dripping or shrinking. There is no need to use any dams to contain the liquid resin.
- If working with a vertical application, apply FAMOWOOD Instant Wood Repair from bottom to top.
- The dispensed resin allows the user to trowel and shape it as the wood surfaces require.
- Polyurethane cures faster at warmer temperatures and slower at cooler temperatures. A large volume of material will cure faster than a small repair.
- Always keep moisture away from uncured polyurethane components. A dry surface will minimize foaming.
- The Part B Side (Hardener) contains Isocyanate. It has extremely low vapor pressure and therefore is very unlikely to become airborne.
- Acetone can be used to assist with clean up of tools and working area.
- Additional product information is available on the Technical Data Sheet. Use the link below to access a PDF of the Technical Data Sheet.
For PRODUCT SUPPORT contact: Technical Support by phone at 800-767-4667 or email info@eclecticproducts.com.
Find out more:
back to FIWR beginning
How To Use
Sell Sheet
Technical Data Sheet
MSDS