Shoe GOO Boots & Gloves Adhesive —
for a protective coating that
extends the life of footwear and gloves.
Make your footwear and gloves last longer by placing a coating of Boots & Gloves to their outside surface before they begin to wearout.
Boots & Gloves can be used to protect shoe toes, glove fingers and more.
Advantages
- Waterproofing: Boots & Gloves is water resistant immediately upon application. Apply Boots & Gloves directly to the surface to be sealed. Use thin coats of Boots & Gloves to build a thick coating on the surface to be sealed, allowing each layer to set 3 to 4 hours. Boots & Gloves hardens by solvent evaporation, so allow time for thorough hardening to ensure proper bonding and wear resistance.
- Repairing worn soles: If a worn boot has a hole that goes all the way through the sole, tape over the hole inside the boot before applying Boots & Gloves to the outer sole. This will help avoid creating a bump. The tape should be removed from the inside and all bumps smoothed out within 2 hours, before the glue is completely hard.
- Fishing and foul weather gear: Some fisherman's waders and foul weather gear have a water-repellent coating that must be removed before Boots & Gloves will adhere. Scrub the area with detergent and allow to dry. Roughen surface before applying Boots & Gloves. If the bond still pulls apart, the repair must be done on the inside surface of the item, which is usually reinforced with fabric.
Use Boots & Gloves to:
- Coat and protect any area of your boots or gloves to avoid premature wear.
- Seals seams, tears, cuts and more on leather, rubber and fabric.
- Repair damaged soles or heels.
Find out more:
How to use Shoe GOO Boots & Gloves Adhesive
Technical Data Sheet (TDS)
Sell Sheet